[PDF]square elevated planter - Rackcdn.comhttps://2ecffd01e1ab3e9383f0-07db7b9624bbdf022e3b5395236d5cf8.ssl.cf4.rackcd...
0 downloads
126 Views
750KB Size
SQUARE ELEVATED PLANTER SM : 400 mm (L) MED : 600 mm (L) LG : 700 mm (L)
400 mm (W) 600 mm (W) 700 mm (W)
500 mm (H) 600 mm (H) 700 mm (H)
IMPORTANT ASSEMBLE THIS PLANTER ON A FLAT LEVEL SURFACE This heritage timber bed is manufactured from the highest quality cypress heartwood. To prevent discolouration over time it is recommended that once assembled the external surfaces are coated with a quality natural oil or stain. Before filling the bed with soil, ensure it is square and level. Be aware that this timber product may splinter so it is recommended that protective gloves are worn during assembly.
KIT CONTENTS
CAPS x 4
STANDARD SLOTTED DOVETAIL BOARDS SM x 2 MED x 2 LG x 2
STANDARD BASE BOARDS SM x 2 MED x 3 LG x 4
NOTCHED BASE BOARDS SM x 2 MED x 2 LG x 2
STANDARD DOVETAIL BOARDS SM x 12 MED x 16 LG x 20
HARDWOOD DOWELS x 4
BRANDED DOVETAIL BOARDS SM x 2 MED x 2 LG x 2
GEOTEXTILE FABRIC x 1
DOVETAIL POSTS x 4
ASSEMBLY IMPORTANT: THIS PLANTER MUST BE ASSEMBLED ON A FLAT LEVEL SURFACE
STAGE 01
STAGE 02
Ensuring the 8mm hole is on the top & the grooved (reeded) side of the timber boards is facing inwards slide in 2 standard & 2 slotted boards opposite to each other.
IMPORTANT The slotted board must go in with the SMALLER section of reeded timber UNDER the slot.
Raise one slotted board resting it on 2 boards, as shown.
STAGE 03
STAGE 04
STAGE 05
Place in notched boards and remaining base boards. The boards will sit at an angle
Once the base boards are installed, hold the 2 support boards and pull them out equally, this will lock the base in.
Slide in the remaining boards ensuring the branded board is on top. Please note: Hold the boards equally allowing the weight of the board to find the correct position.
STAGE 06
STAGE 07
STAGE 08
Insert the 4 hardwood dowels into the holes on the top of the posts by hand and then place 4 caps over these dowels. Push down to secure. Optional: Wood glue can be used to fix the cap in place.
Lay the black geotextile fabric in evenly. Allow excess fabric to lay up the walls. Start filling by placing the soil into each corner of the planter whilst holding the fabric up, this will prevent soil from washing away once filled.
Completed Planter